|
| |
Putting it On!
 |
 |
INSTALLATION AND CARE INSTRUCTIONS
Putting It On!!
WET IT FIRST—A wet shield works better!
Your SCUBA Shield ™ is
properly installed as follows:
- Place the open end (large) over the valve, and then work the small
end opening over the tank valve; valve handle first, and then the valve
body itself.
- Orient the long seam forward (the way you are facing when wearing
the tank). The short seam will face outwards away from the BC (see
photo).
- Slide the material down over the tank and allow the closed end to
stretch and snap over the bottom. Smooth out any wrinkles and go diving!
Make sure the BC strap is tight.
Properly Installed!
Care and Feeding Instructions
The SCUBA Shield™ is
constructed of a high quality, polyester Spandex fabric. With proper
care, the material will last a multitude of dives, without fading or color
changes.
- As with all of your dive gear, your SCUBA Shield should be rinsed
with fresh water following each dive day, and hung to dry before using
again.
- After returning home from a dive trip, launder your SCUBA Shield as
you would any fine article of clothing; e.g. a cold water wash in a mild
detergent and hang to dry.
- After drying completely, roll tightly, and return to the original
packaging.
|
| |
 |
 |
|
